Simoniz 039-8582-6 Instruções de Operação descarregar pdf (Página 19)

Cleaning and Maintenance

Checking Air Filter

Inspecting, Replacing or Cleaning the

Spark Plug

The spark plug should be checked after every 100

hours of operation or every six months.

To replace or clean the spark plug:

1. Disconnect the spark plug wire by pulling it off the

spark plug.

2. Using provided spark plug wrench (J), remove the

spark plug by turning it counter-clockwise. If there

is a carbon sediment build-up, remove it. If there is

too much carbon sediment, replace the spark plug.

3. Check the gap with a wire gauge. If necessary,

reset the gap to 0.7-0.8 mm. Install and tighten the

spark plug to the recommended torque – 180 lb.·in

(20 Nm).

4. Reinstall the spark plug wire and protection cage

in reverse order.

NOTE:

In some areas, local law requires using a

resistor spark plug to suppress ignition signals. If this

engine was originally equipped with a resistor spark

plug, use the same type for replacement.

Press the right side of air cleaner housing and

take it down. Take the air filter down and use

water to clean. After cleaning, soak it into

kerosene. Then put back the air filter to air

cleaner, and fix the air cleaner housing.

IMPORTANT

Clean air filter (6) element after every 50 hours of

use (every 10 hours under dusty conditions). Wash

in high flashpoint solvent, squeeze dry, dip in clean

engine oil, and squeeze out excess oil.

IMPORTANT

Used oil is a hazardous waste product and must be

disposed of properly. Do not discard with household

waste. Check with your local authorities, service

centre, or

Canadian Tire

for safe disposal/recycling

facilities.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Sem comentários

Simoniz 039-8582-6 Instruções de Operação Página 19